9
For more cool and exciting Wattage products, visit our website at http://watt-age.globalhobby.com
❑
With both wing panels pushed firmly together, apply
a strip of clear tape to the top of the wing joint.
❑
Use scissors to trim the ends of the tape flush with
the wing, then turn the wing over and apply a strip to the
bottom of the joint.
The tape will keep the wing panels from pulling apart
during flight. Do not omit this procedure.
❑
Repeat the previous procedures to install the second outer wing panel to the center wing panel.
Step 5: Installing the Tail Assembly and Pushrods
❑
Insert the Z-Bend in one pushrod wire into the third
hole out from the base of the elevator control horn.
IMPORTANT
Install the Z-Bend so that the longer portion of the pushrod
wire faces toward the middle of the horizontal tail as
shown.
❑
Turn the horizontal tail right-side up and carefully
slide the plain end of the pushrod wire into the pushrod
exit hole in the right side of the fuselage.
❑
Push the stabilizer forward until it rests on top of the
mounting platform on the fuselage.
Fuselage shown upside down for photo clarity.