11
For more cool and exciting Wattage products, visit our website at http://watt-age.globalhobby.com
❑
Turn the fuselage upside down and slide one flat
washer onto each vertical tail mounting stud.
❑
Thread one hex nut onto each mounting stud and
tighten them both finger-tight.
❑
Use an adjustable wrench to tighten the hex nuts
firmly to draw the tail assembly down into place.
The tail assembly should be firmly tightened down
into place.
❑
Insert the Z-Bend in the remaining pushrod wire into
the third hole out from the base of the rudder control horn
that you removed previously.
IMPORTANT
Install the Z-Bend so that the longer portion of the pushrod
wire faces toward the right side of the control horn as
shown.
❑
Slide the plain end of the pushrod wire into the
pushrod exit hole in the left side of the fuselage.
❑
Slide the plain end of the pushrod wire through the
small hole in the side of the pushrod connector.
If the pushrod wire won't slide through, loosen the
set screw on top of the connector.
IMPORTANT
Don't tighten the set screw at this time.