10
Need help or have any questions? Call us at 1-714-963-0329 or send us an email at [email protected]
❑
Push the horizontal tail back far enough to allow
room to slide the end of the pushrod wire through the
adjustable servo connector.
❑
Carefully slide the end of the pushrod through the
small hole in the side of the connector.
If the pushrod wire won't slide through, loosen the
set screw on top of the connector.
IMPORTANT
Don't tighten the set screw at this time.
❑
Remove the two hex nuts and two flat washers that are preinstalled on the vertical tail mounting studs.
❑
Remove the nylon rudder control horn using a phillips screwdriver to remove the two machine screws. Set the
control horn, backplate and screws aside for now.
IMPORTANT
The control horn must be removed to install the vertical tail.
❑
Line up the two tail mounting studs in the vertical
tail with the two holes in the horizontal tail.
❑
Line up the assembly and carefully push the vertical
tail down until the mounting screws extend out the bottom
of the fuselage.
You may have to move the horizontal tail slightly to
allow the mounting screws to pass through easily.