WATT MIGNON6, Руководство пользователя

Страница: 83 / 97

page 31 of 42
Cleaning of the hit fire
Remove the fire shield following the instructions indicated in the pictures. (Pict. 14-15-16-17).
Use a vacuum cleaner to clean the upper part from the residual ash. Once finished, install the fire shield
being sure the 3 support hooks have been placed correctly.
Holding hangs Pict. 14: Lift the fire shield
Pict. 15: Lift the fire shield Pict. 16: Rotate the fire shield Pict. 17:Remove the fire shield
Ash box
Open the door and extract the ash box. Use a vacuum to remove all
the ash deposited within. This operation must be performed more or
less frequently depending on the quality of the pellets used (Pict. 18-
19).
Cleaning the glass
The glass is a self cleaning type, therefore, while the stove is working, a veil of air is blown across its
surface to remove ash and dirt; nevertheless over a period of several hours, a greyish patina tends to
form which should be cleaned when the stove is next shut down. How dirty the glass becomes also
depends on the quality and quantity of pellets used.
Cleaning the glass should be done when the stove is cold with products recommended and tested by
our company. When performing this operation, always check that the grey seal around the glass is in
a good state; failure to check the efficiency of this gasket can compromise the function of the stove.
Poor quality pellets can, in any case, cause the glass to become dirty.
1) push
upwards
2) rotate
EN