Waterstage WGHA050DG, Техническое руководство

Страница: 68 / 151

- (CS01 - 14) -
Control system
- (CS01 - 14) -
C
O
N
T
R
O
L
SY
S
T
E
M
C
O
N
T
R
O
L
SY
S
T
E
M
LINE
ACCESS
LEVEL
FUNCTION
SETTING RANGE
OR DISPLAY
FACTORY
SETTING
Heating circuit 2
1010 U Comfort setpoint
Reduced setpoint…
Comfort setpoint maximum
20°C
1012 U Reduced setpoint
Frost protection setpoint…
Comfort setpoint
19.0°C
1014 U Frost protection setpoint
4°C… Reduced setpoint
8.0°C
1016 S Comfort setpoint maximum Comfort temp... 35 °C 28.0°C
1020 I Heating curve slope
0.1…4
0.5
1021 I
Off-set of the heating curve -4.5…4.5°C
0°C
1030 I
Summer / winter heating limits
8...30 °C 18°C
1040 I Flow temp setpoint min
8…70°C
17°C
1041 I Flow temp setpoint max
8…70°C
55°C
1050 S
Room influence
1...100% 50%
1060 S Room temperature limitation
0.5…4°C
0.5°C
As soon as the room temperature = [Setpoint line 1010 (ex. 20°C) + Room temperature
limitation setpoint line 1060 (ex. 0,5 °C)] > 20,5 °C => The heat pump is stopped.
It restarts when the room temperature falls below the setpoint (in the example, Room
temperature < 20,0 °C).
1080 S Quick setback
Off
Down to reduced setpoint
Down to frost prot setpoint
Off
1090 S
Optimum start control max 0…360 min
180 min
1091 S
Optimum stop control max 0…360 min
30 min
1100 S Reduced setpoint increase start
---, -30…10°C
---°C
1101 S Reduced setpoint increase end
---, -30…10°C
-5°C
1130 S Mixer valve boost
0…50°C
0°C
1134 S Actuator running time
30…873sec
240sec
1150 I Floor curing function
Off
- Off: Early interruption of the current programme, programme inactive.
- Operational heating.
- Heating ready for occupation.
- Operational h ready heating.
- Ready h operational heating.
- Manual: Manual mode enables you to programme your own concrete slab drying time.
The function ends automatically after 25 days
1151 I Floor curing setpoint manually
(if line 1150 = manual)
0…95°C
25°C
This function enables you to set the custom concrete slab drying temperature. This
temperature remains fixed.
The concrete slab-drying program stops automatically after running for 25 days.
1156 I Floor curing day current 0... 32
1157 I Floor curing day completed 0... 32 0
1200 S
Operating mode changeover
None, Protection mode,
Reduced, Comfort,
Automatic Reduced
Domestic hot water
1600 U
Operating mode Off, On, Eco On
1610 U Nominal setpoint Reduced setpoint (line
1612)…65 °C
55°C
The backup electrical system is required to reach this level.
1612 U Reduced setting 8 °C...Nominal setting
(line 1610) 40°C