Wahlberg 241, Руководство пользователя

Страница: 20 / 40

241.805.012 20 Date: 2017-10-24
Manual reset
When the winch is ready, the first thing to do is to reset it. This is done manually in
MODE 2 on DMX channel 6.
Reset example:
− The DMX channel 6 is set to 30%
→
the winch starts to roll up the wire.
− When the snap hook approaches the motor house reduce the speed by reducing
the DMX channel 6 input. High speed can damage the winch and wire.
− Let it run until the snap hook, at the end of the wire, reaches the motor-house.
The winch is now reset and the soft TOP limit is at the build-in motor-house top (10 cm
below).
If you want to have a lower soft TOP limit, simply just set the DMX channel 6 to 0% and
the place where the winch stops is your new soft TOP limit.
The soft BOTTOM limit is set in the same way, just using DMX channel 7 instead.
Positioning
When the winch has been reset and the soft TOP limit is set, it is possible to use it for
positioning run.
The green LED next to the MODE selector indicates by
− Fast flashing The winch needs to be reset, before it can be used.
− Slow flashing The winch’s load is moving towards the set position
− Steady light The set position has been reached and the motor has stopped.
The position is set on the DMX channel 1 and 2, which controls the rough-and fine-
position. Where 100 % is the soft TOP limit and 0 % is the soft BOTTOM limit.
The speed is set on the DMX channel 3, where 100 % is the fastest and 0 % is the
slowest.
The winch does not run unless the DMX channel 3 is set above zero, and DMX channel
3, therefore also works as a main brake.