Wahlberg 241, Руководство пользователя

Страница: 15 / 40

241.805.012 15 Date: 2017-10-24
Set up
Warning! Read “Safety Information” on page 2 before installing, powering,
operating, or servicing the Winch 10.
Warning! Before running the winch, it is important to put a counterbalance on the
wire. This is necessary, as the slack detection switch otherwise will be activated
and stop the winch.
Warning! Only experienced DMX users should operate the winch. Contact Wahlberg
for further information and education on DMX protocol.
Block diagram
A block diagram of the control system can be found in Appendix 3.
Counterbalance - Slack Wire
To ensure proper and tight winding of the wire on the drum, the winch is equipped
with a slack detections device, that stops the motor if the wire is loose or wire slack
detected.
Therefore, when the winch is mounted, ensure that the winch has some kind of
counterweight attached to the wire hook, if not, the winch will not work properly, and
will not lower down.
Connections
The winch has 4 plugs. At the top there are 2 DMX plugs, one for connecting DMX in
and one for daisy chaining the DMX connection to other devices.
Below there is a power connection plug for POWER in, and one plug that can be used to
daisy chain the power connection between multiple devices.
Below those plugs are the voltage selector and the fuse. It is important that the
voltage selector has been set to the appropriate voltage before power is applied to the
winch.