Wahlberg 241, Руководство пользователя

Страница: 3 / 40

241.805.012 3 Date: 2017-10-24
− Isolate the winch from power immediately if the power plug or any seal, cover,
cable, or other component is damaged, defective, deformed, wet, or showing
signs of overheating. Do not reapply power until repairs have been completed.
−
Do not expose the winch to rain or moisture.
−
Refer any service operation not described in this manual to a qualified
technician.
PROTECTION FROM BURNS AND FIRE
−
Do not operate the winch if the ambient temperature (Ta) exceeds 40°C (104°F).
−
The exterior of the winch becomes warm during use. Avoid contact by persons
and materials. Allow the winch to cool for at least 10 minutes before handling.
− Do not modify the winch in any way not described in this manual.
−
Install only genuine Wahlberg parts.
PROTECTION FROM INJURY
− Fasten the winch securely to a fixed surface, rig, or structure when in use. The
winch is not portable when installed.
− Ensure that any supporting structure and/or hardware can hold at least 10 times
the weight of all the devices including their load.
− If suspending from a rigging structure, fasten the winch using the supplied
Manfrotto slim coupler and M12 bolt, nut, and washers supplied with the winch
according to the manual, see page 11.
− Always install the winch as described in this manual. If the winch is installed in a
location where it may cause injury or damage if it falls, install as described in
page 11.
− If possible, allow enough clearance beneath the winch so it cannot cause any
danger to personnel beneath it.
− Check that all external cobblers and rigging hardware are securely fastened.
− Block access below the work area and from a stable platform whenever installing,
servicing or moving the winch.
− Do not operate the winch with missing or damaged covers, shields, or wire.
− Do not use the winch over the head of people
−
Do not use the winch to lift people or animals.
− Only use the winch to lift static loads.
Inspection
points
Intact wire
Broken wire
Before each use
− Check that the winch is safely and correctly installed/mounted.
− Inspect the entire length of the wire rope for bends, damage
and wear, cut cords, corrosion and abuse.
− Inspect the wire ferrule crimp and thimble for damage, wear,
corrosion or abuse.
− Secure that the load is safely attached and weighs maximum 10
kg (22.0 lb).
− Check all limit switches
− Check the slack detection device
Warning! Do not use the winch if any damage or error is found!