241.805.012
29
Date: 2017-10-24
8.
Take the PVC tube out of the TRAFO-plate.
9.
Carefully lift off the TRAFO-plate and tilt it. Ensure that none of the wires and plugs
is damaged during this operation.
10.
Take out the wire-wheel and cut off the wire-eye of the old wire, allowing to
remove the old wire
11.
Cut off 10.6 m 2mm 7x7 galvanized steel wire rope (approved by Wahlberg)
12.
Put the new wire through the ‘top stop’ and through the hole in the wire-wheel.
13.
Form an eye with the new wire and a ferrule (approved by Wahlberg), using the old
eye as template.
14.
Place the eye over the axel of the wire-wheel.
Содержание 241
