Wahlberg 241, Руководство пользователя

Страница: 9 / 40

241.805.012 9 Date: 2017-10-24
Winch 10 should only be operated by an experienced DMX-controlled-lighting-desk-
operator.
The lighting desk has to be programmed according to the manual, so the winch will
stop when the speed is put to 0 %. It is also possible for the user to stop the winch by
disconnecting it from the main. After power failure the start position of the winch
needs to be reset before the winch can function again.
Manual operation of the winch is only intended for mounting, service, and tests.
Area of use
For indoor use only!
Caution! To reduce the risk of electric shock or injury: use indoors only
Caution! To reduce the risk of electric shock, do not expose to rain: store indoors!
The winch is intended for indoor use only. It is designed for lifting and lowering
material at the weight and speed stated in "Technical specifications" on page 6. Any
other use of the winch may result in a risk of injury of persons or equipment damage.
Exceeding the load rating may cause failure of the equipment.
Use only approved rigging connectors to secure the load to the wire and do not wrap
the wire around the load as this will damage the wire and result in a risk of injury of
persons or equipment damage.
Do not modify the winch. For any modification of your winch, contact Wahlberg.
It is the customer's sole responsibility to comply with any relevant local laws,
regulatory requirements, and restrictions, concerning the use of the winch.
Using for the first time
Important! The Winch 10 must be protected from environmental factors such as
physical shocks and vibration during storage.
Warning! Read “Safety Information” on page 2 before installing, powering,
operating, or servicing the winch. Before applying power to the winch:
−
Check the Wahlberg Motion Design website at www.wahlberg.dk for the most
recent documentation and technical information about the winch 10. Wahlberg
user manual revisions are identified by the revision number in the bottom of each
page.
−
Carefully review the “Safety Instructions” on page 2.
− Check that the local AC mains power source is within the winch power voltage
and frequency ranges.
− See “Power cables and power plug” on page 2. Install a Neutrik powerCON TRUE1
NAC3FX-W power input connector on a suitable power cable. If using the power
from a mains power outlet, install a suitable power plug on the power cable.