241.805.012
11
Date: 2017-10-24
Physical installation
Warning! The winch must be either fastened to a flat surface such as a roof, or
clamped to a truss or similar structure in such a way that the wire exit points
downwards. Do not apply power to the Winch if it is not securely fastened.
Warning! If fastening the winch to a flat surface, the supporting surface must be
hard and flat. Fasten the winch securely.
Warning! If mounting the winch on a truss, use only the supplied rigging clamp and
M12 bolt. The clamp must be screwed into the central hole in the winch’s mounting
bracket using the supplied M12 washers and M12 locking-nut.
Fastening the winch to a flat surface
The Winch 10 can be fastened to flat surface such as a roof. Check that the surface
can support at least 10 times the weight of all winches and equipment to be installed
on it.
Mounting the winch on a truss
The Winch 10 can be clamped to a truss or similar rigging structure.
To clamp a Winch 10 to a truss:
1.
Check that the rigging clamp is undamaged and that the rigging structure can
support at least 10 times the combined weight of all winches and equipment to
be installed on it.
2.
Use the supplied rigging clamp or contact Wahlberg Motion Design for a
replacement.
3.
Fasten the clamp to the winch with the supplied M12 bolt, nut, and washers in
the hole in the mounting clamp of the winch.
4.
Block access under the work area. Working from a stable platform, hang the
winch on the truss with the wire downwards. Tighten the rigging clamp.
Содержание 241
