Wahlberg 241, Руководство пользователя

Страница: 26 / 40

241.805.012 26 Date: 2017-10-24
Wire defect
If the wire in any way gets damaged, stuck, or have problems winding on and off, the
wire and wire roll-up needs to be inspected.
This can be done the following way:
1. Disconnect the power.
2. Remove the 6x M3 hexagonal socket screws, on one of the middle plates.
3. Take off the loose middle plate, to look into the winch. See the picture below
4. If the wire is not tight around the wire-wheel, or it is bungled up inside, the wire
needs to be unravelled.
− This is done by manually unravelling and loosening the wire and pulling it
out of the winch.
− It can be necessary to remove the other middle plate to work it out of the
winch properly.
5. If the wire is bended or damaged, it has to be replaced.
− Refer to the section Wire discard criteria for information on wire discard
criteria.
− Read the section Changing wire to learn how to replace the wire.
6. If the wire is okay it must be rolled on again.
7. Mount the middle plate on the winch using the 6x M3 hexagonal socket screws
and tighten them slightly.