Wahlberg 241, Руководство пользователя

Страница: 17 / 40

241.805.012 17 Date: 2017-10-24
MODE Function Description Note
0 Neutral Mode The motor is not powered and the winch does not move.
1 Positioning
AUTO reset
The winch resets automatically and thereby also sets the
soft TOP limit automatically.
The winch runs up until the snap hook reaches the motor-
house and stops. Because of this, the soft TOP limit in this
MODE will always be at the motor-house.
To start the automatic resetting, speed must be added on
the speed-channel (DMX channel 3).
When the winch has been reset, it is possible to use it in
positioning mode.
2 Positioning
MANUAL reset
The winch is manually reset on the DMX channels 6 or 7.
The soft TOP limit is, because of this, also set manually,
which makes it possible to decide the position of the soft
TOP limit.
It is highly recommended to set the soft TOP limit at the
motor-house. When the winch has been reset, it is possible
to use it in positioning mode.
Warning! When
resetting in MODE
2, decrease the
speed, as the
load is closing in
on the winch,
otherwise the
lifting cable and
winch can be
damaged
3,4,5,6 No function assigned The winch stops
7 Manual run up
(no DMX needed)
The winch runs up with the speed set on the DMX-selectors.
This function can be used as a test-function or in association
with on- and off-applying of wire.
E.g. Set the winch to MODE 7 and the DMX address to 100,
for a slow movement, or set the DMX address to 500 for fast
movement.
Warning! Only for
service and tests!
8 Manual run up
(no DMX needed)
The winch runs down with the speed set on the DMX-
selectors.
This function can be used as a test-function or in association
with on- and off-applying of wire.
E.g. Set the winch to MODE 8 and the DMX address to 100,
for a slow movement, or set the DMX address to 500 for fast
movement.
Warning! Only for
service and tests!
9 Re-calibrating
overload
See page 21 Warning! Only for
service and tests!
Table 2 - Overview of MODE functions