59
3. Use
the
Up
and
Down
arrow buttons to select a field to change, from the following options:
Enable
-enables the recording schedule.
Mon through Sun -
enables recording on the specified days of week.
Start Hour/Minute/Second -
sets the exact time when the recording starts.
Stop Hour/Minute/Second -
sets the exact time when the recording ends.
Camera 1 through 16 -
sets the recording mode for the selected camera. Select Normal Record to record
continuously. Select Motion Detect to record only when motion is detected. Select OFF to disable
recording.
Audio -
enables recording of sound along with the video signal.
Frame Rate Setup -
sets the frame rate for recording. Set Auto Speed to Yes and the device evenly
divides the recording frame rate amongst all cameras. If set to No, you can manually set up the individual
frame rates for each camera.
Weight recording-
weight recording is setting special recording frame rate when an alarm of one of
camera was triggered.
4. Use
the
Right
and
Left
arrow buttons to change the value of that parameter.
5. Use
the
Prev
Page and
Next
Page
buttons to move to the previous or next page.
6. Press
the
OK
button when all parameters are set.
4.4.3 Motion
Detection
To set motion detection conditions:
1. Use the
Up
and
Down
arrow buttons to select the
Motion Detection
option from the
Alarm
menu and
press the
OK
button.
2. When the motion detection menu appears, uses the
Up
and
Down
Arrow buttons to select one of the
following options:
• Enable
– configures the motion detection feature for each camera.
• Sensitivity
– sets the sensitivity value for detecting motion.
• Set Detect Area
– sets the area in the camera’s field of vision over which motion is detected. This
option is displayed only after you set the
Enable
option to
Yes
.
• Enable all area
– sets the all area is motion detect area.
• Disable all area
–set no area is motion detect area.
3. Select the
Enable
field and use the
Left
and
Right
arrow buttons to toggle between
Yes
, to enable the
motion detection feature, and
No
, to disable it.
4. Select the
Sensitivity
choice and use the
Left/Right
arrow buttons to decrease/increase the sensitivity.
We recommend that you keep the sensitivity level to its default setting. If the sensitivity level is
adequate, an orange square is displayed in the upper left-hand corner of the screen when motion is
detected.
5. Select the
Set Detect Area
option and press the
Right
arrow button to configure the area as follows:
i. The highlighted area in red is the area monitored by motion detection. Use the
Arrow
buttons to
move the cursor.
ii. Press the
OK
button to cut off any areas where you want to disable motion detection. If you want
motion detection enabled in the entire field of vision of the camera, leave the screen completely red.
