VTAC HSD USER MANUAL: SECTION 7
VIRGINIA PANEL CORPORATION
1/9/19
7-1
For the most current information available, visit vpc.com
VTAC HSD RIGHT ANGLE INSERT PCB INSTALLATION INSTRUCTIONS
PART # 610 151 104
Figure B.
Install insert(s) with contact surface fl ush with tool edge.
Figure A. Installing the VTAC HSD Right Angle Insert (Insertion Tool).
TOOLS REQUIRED
VTAC HSD Right Angle Insert Installation Tool, Part # 910 112 132
INSERT INSTALLATION INSTRUCTIONS
1. Load the desired number of inserts into the tool.
The insert(s) should
be loaded starting from the center of the tool and evenly
distributed outward. The center position is marked by the holes as
shown in
Figure A
.
2. Align the front of each insert with the edge of the tool as shown in
Figure B
.
3. Position the insert(s) so that the top surface of each insert(s) is
fl ush with the inner surface of the tool as shown in
Figure C
.
Figure C.
Top surface of insert(s) must sit fl ush with tool surface.
CENTER POSITION
LOCATING HOLES
FLUSH
FLUSH
FRONT
TOP
SURFACE
