VTAC HSD USER MANUAL: SECTION 7
VIRGINIA PANEL CORPORATION
1/9/19
7-6
For the most current information available, visit vpc.com
INSERT INSTALLATION/REMOVAL INSTRUCTIONS FOR RECEIVER MODULE
PART # 310 130 XXX
TOOLS REQUIRED
Philips screw driver
INSERT INSTALLATION INSTRUCTIONS
1. Install
VTAC HSD Right Angle
Insert(s) onto PCB see
Section 7-1
.
2.
Ensure that the VTAC HSD Double Ended Insert(s) is aligned with
the corresponding module position. Apply gentle pressure and
insert the VTAC HSD Double Ended Insert(s) into the rear (wiring
side) of the module as shown in
Figure A
. The VTAC HSD Double
Ended Insert(s) can only go in one way.
3. Engage Module with VTAC HSD Double Ended Inserts onto VTAC
HSD Right Angle Inserts as shown in
Figure B
.
4. Attach the bracket to PCB with the PCB to bracket mounting
screws, do not tighten completely. Then secure the PCB
Assembly to module with module to bracket mounting screws.
Torque #2-56 and M2 screws to 1.5 in-lbs [0.17 Nm] shown in
Figure C
.
Figure A. SIM Double HSD Insert Installation.
REAR MATING SIDE
OF 610151103
Figure B. Engage Module with VTAC HSD Double
Ended Insert onto SIM Right Angle HSD Inserts
Figure C. Install PCB to Module Brackets
BRACKET
MOUNTING HOLE
MODULE TO BRACKET
MOUNTING SCREW (1)
2-56
PCB TO BRACKET
MOUNTING SCREW (2)
M2
BRACKET
REAR WIRING SIDE
FRONT
