VTAC HSD USER MANUAL: SECTION 2
VIRGINIA PANEL CORPORATION
1/9/19
2-3
For the most current information available, visit vpc.com
VTAC HSD INSERT INSTALLATION/REMOVAL INSTRUCTIONS FOR ITA MODULE
PART # 510 171 101
Figure A. VTAC HSD insert installation.
Figure B. Insert removal tool pins.
TOOLS REQUIRED
VTAC Extraction Tool Kit, Receiver and ITA, Part # 910 112 130
VTAC HSD INSERT INSTALLATION INSTRUCTIONS
1.
Ensure that the VTAC HSD Insert(s) is squared up with the
corresponding module location. Apply gentle pressure and insert
the VTAC HSD Insert(s) into the rear (wiring side) of the module
shown in
Figure A
. The VTAC HSD Insert(s) can only go into one
side. Once in place, gently pull the wire to ensure the insert(s) is
fully seated.
NOTE: To be fully seated, The insert(s) back shoulder should be fl ush or
below the module rear face as shown in
Section 2-1 Figure C.
When
plugging a stack of inserts, the blue insert will always be on top as
shown in
Section 2-1 Figure A.
VTAC HSD INSERT REMOVAL INSTRUCTIONS
1. Group the required number of extraction tools together for the
given VTAC HSD patchcord shown in
Figure B
. The tool pins should
be on opposite sides of the patchcords or wires to be removed.
WARNING
: All inserts within each patchcord must be extracted
simultaneously to prevent damage to VTAC HSD Inserts.
NOTE: The extraction tools are magnetic to aid in stacking them
together.
2. While grasping the extraction tool(s) body from the sides, (
Figure
B),
slide tool pins into module’s extraction cavity slots until the tool
frame is seated against the body shown in
Figure C
.
WARNING:
The extraction tool(s) need to be seated against the
module front face before the plunger is pushed in. Otherwise
damage to insert(s) may occur.
3. Push plunger of extraction tool(s) in to extract VTAC HSD Insert(s).
The insert(s) will be ejected out the wiring side of the module
shown in
Figure D
.
Figure C. Seat removal tool to module frame.
Figure D. Push removal tool plunger.
GRIP
DETAIL A
EXTRACTION TOOL
PINS
SEAT
PUSH
PLUNGER
PLUNGER
BLUE INSERT
