VTAC HSD USER MANUAL: SECTION 8
VIRGINIA PANEL CORPORATION
1/9/19
8-1
For the most current information available, visit vpc.com
INSERT INSTALLATION/REMOVAL INSTRUCTIONS FOR ITA AND RECEIVER MODULE
PART # 610 151 105
TOOLS REQUIRED
VTAC Extraction Tool Kit, Receiver and ITA, Part # 910 112 130
INSERT INSTALLATION INSTRUCTIONS
1. Install
VTAC HSD Right Angle
Insert(s) onto PCB see
Section 7-1
.
2. Fasten VTAC HSD Retention Insert to PCB with M1x 0.59" screws.
3.
Ensure that the VTAC HSD Double Ended Insert(s) is aligned with
the corresponding module position. Apply gentle pressure and
insert the VTAC HSD Double Ended Insert(s) into the rear (wiring
side) of the module shown in
Figure A Section 7-2 and Section
7-3.
The VTAC HSD Double Ended Insert(s) can only go in one
way.
4. Insert VTAC HSD Right Angle Inserts into Module and VTAC HSD
Double Ended Inserts shown in
Figure A
.
INSERT REMOVAL INSTRUCTIONS
5. Extract VTAC HSD Right Angle Insert(s). The PCB assembly will
extract as shown in
Figure B
.
NOTE: VTAC HSD Double Ended Inserts will remain in module.
6. Extract VTAC HSD Double Ended Insert per
Section 2-2
NOTE: VTAC HSD Right Angle Retention Insert’s latches will retain the
small PCB assembly.
NOTE: (1) Retention Grid limited to (6) VTAC HSD Right Angle Inserts.
Figure A. Insert VTAC HSD Right Angle Inserts into
Module and VTAC HSD Double Ended Inserts
(Receiver Module Shown)
VTAC HSD
RETENTION INSERT
Figure B. Small PCB Extraction (Receiver Module Shown)
PUSH
PLUNGER
