VTAC HSD USER MANUAL: SECTION 10
VIRGINIA PANEL CORPORATION
1/9/19
10-2
For the most current information available, visit vpc.com
INSERT INSTALLATION INSTRUCTIONS (CONT’D)
4. To use the vertical header insertion tool, the PCB must be designed to accept the alignment pins of the insertion tool. The distance
between these two alignment holes is identifi ed on the drawing of part # 610 151 107.
5. With the tool’s top removed from its base, insert the alignment pins into the alignment holes of the PCB (
Figure A
).
6. Ensure that the compliant pins of the insert align with the plated thru-holes on the PCB board. For info on the spacing of these holes,
consult the drawing for part # 610 151 107 (
Figure B
).
7. With the base and PCB together, place the top on to the base of the insertion tool (
Figure C
).
8. Press the top insertion tool onto the base, pushing the compliant pins of the insert into the PCB.
Do not over press.
Remove the PCB
from the tool, and verify the installation of each insert in the PCB is correct. The insert should be fl ush to the PCB with a gap of no more
than .004” [.10 mm].
NOTE: Each insert requires 10 lbs [4.54 kg] of force to create a gas-tight seal when installed. Inserts should not be removed once
in place. Visually inspect the pin side of the PCB to ensure proper pin insertion with the PCB.
Figure D. Finished inserts installed properly on a PCB.
Figure C. Insertion tool is ready to press.
VTAC HSD VERTICAL INSERT PCB INSTALLATION
INSTRUCTIONS FOR 90 SERIES MODULES
PART # 610 151 107
Figure A. The PCB should have alignment holes to
accept the alignment pins of the insertion tool.
Figure B. Compliant pins align with the thru-holes of the PCB.
ALIGNMENT HOLES FOR
THE ALIGNMENT PINS OF
INSERTION TOOL
PRESS-FIT TAILS OF INSERT
SHOULD ALIGN WITH
THRU HOLES
