VTAC HSD USER MANUAL: SECTION 7
VIRGINIA PANEL CORPORATION
1/9/19
7-5
For the most current information available, visit vpc.com
INSERT INSTALLATION/REMOVAL INSTRUCTIONS FOR ITA AND RECEIVER MODULE
PART # 510 170 101 AND 510 171 101
TOOLS REQUIRED
Philips screw driver
INSERT INSTALLATION INSTRUCTIONS
1
.
Install VTAC HSD Right Angle Insert(s) onto PCB see
Section 7-1
.
2
.
Ensure that the VTAC HSD Double Ended Insert(s) is aligned with
the corresponding module position. Apply gentle pressure and
insert the VTAC HSD Double Ended Insert(s) into the rear (wiring
side) of the module as shown in
Figure A
. The VTAC HSD Double
Ended Insert(s) can only go in one way.
3. Engage Module with VTAC HSD Double Ended Insert(s) onto
VTAC HSD Right Angle Insert(s) as shown in
Figure B
.
4. Attach bracket to PCB with the PCB to bracket mounting screws,
do not tighten completely. Then secure the PCB Assembly to the
module with module to bracket mounting screws. Torque #2-56
aand M2 screws to 1.5 in-lbs [0.17Nm] shown in
Figure C
.
Figure A. VTAC HSD Double Ended Insert Installation
REAR MATING SIDE
OF 610151103
Figure B. Engage Module with VTAC HSD Double
Ended Inserts onto VTAC HSD Right Angle Inserts
Figure C. Install PCB to Module Brackets
BRACKET MOUNTING
HOLE (2)
MODULE TO BRACKET
MOUNTING SCREW (2)
2-56
PCB TO BRACKET MOUNTING
SCREW (4) M2
BRACKET
BRACKET
REAR WIRING SIDE
FRONT
