20
CLEANING
100 uS/cm
•
The system is performing a cleaning in
place (CIP).
•
Average conductivity of the last 5 cycles is
also presented.
PROCESS/CIP
STEP
PROCESS/CIP
STEP
110/110
• In this screen you can see the process or
CIP step currently active.
• For a detailed explanation of all the process
steps please refer to chapter 7.2.1
• The numbers below the process/CIP step
represents the total time of the step and
the
time remaining in seconds.
CIP CYCLES
Cycle count displays the complete cycles remaining until the next CIP. A CIP
occurs by default after 432 cycles. After a complete cycle (Prepure -Pure -
Waste - HF Waste) the Cycle counter is reduced by 1. When the Cycle counter
reads
Cycle: 0/432
a CIP step will follow.
TOTAL PURE
VOLUME
The total pure volume produced in litres or gallons since the start of
operation.
RECOVERY
5 cycle averaged water recovery of the system.
INSTANT FLOW
Current flow
ALARM
All the alarms are presented in 3 forms:
If the alarm never occurred.
Alarm type: NO
1/1/1 0:0
If the alarm is currently active.
Alarm type: YES
yy/mm/dd/ time
To acknowledge the alarm press, ENTER.
If the alarm occurred in the past and it is already acknowledged/resolved.
Alarm type: NO
yy/mm/dd/ time
For a more detailed explanation of all the alarms please refer to chapter 7.2.2
8.2.1
Process steps
PROCESS STEPS
STEP Name
LCD Name
Description
Idle
IDLE
System powered but not operating. The Idle step is potentially
caused by an alarm during operation or if operation was
abruptly stopped.
Prepurify
PREPURIFY
Occurs after waste step, flushes any remaining wastewater
from the module.
Содержание DiUse
Страница 1: ...DiUse Owner s Manual Installation and Operation...
Страница 33: ...32 P ID...
Страница 34: ...33 PROCESS FLOW DIAGRAM...
Страница 35: ...34 DIUSE INSTALLATION PFD...