• Press the up button (7) and down button (6) to select the desired layer thickness
value. Confirm your selection with the confirmation button
(4).
• Press the up button (7) and the down button (6) to select the desired tolerance
value. Confirm your selection with the confirmation button
(4) to start measuring with
average measurement.
• Measure three times in a limited area on the measured object. The measuring device deter-
mines the average of the three consecutive measurements as a measured value for area A.
• Measure three times in a limited area on the measured object again. The measuring device
determines the average of the next three consecutive measurements as a measured value
for area B.
• Repeat this method three more times for points C, D and E. The measured average value is
taken as a measured value for the measured surface.
• After the measurement series has been completed, the average value of the series as well
as ‘PASS’ or ‘FAIL’ are displayed on the LC display (2). If ‘PASS’ is displayed, the tested
workpiece is good. If ‘FAIL’ is displayed, the workpiece is a reject or needs to be reworked.
First measured value
Second measured value
Third measured value
Average value from A, B, C,
D and E
Average value
of a measured
surface
Press the Clear button (5) to return to average measurement and continue measuring. Then,
repeat the measurement procedure outlined above for all five measured surfaces.
• Press and hold the Clear button (5) to exit average measurement and stop measuring.
41
