1234_BA_E_Rev0 - VOLspeed Giant Syncdrive Sport/Pro V4
© TLI Elektronik GmbH
16
6.5
Check function
►
Insert the battery into the e-bike.
►
Turn on the e-bike. When the e-bike is switched on for the first time, an automatic initialization is
performed. The display shows the speed 11km/h (6.8mph) for 10 seconds. Then the display
shows 0km/h (0mph) again. The initialization is now complete.
Check display indication
If the display shows 12km/h (7.5mph) after the 10 seconds, the wiring of the module is
faulty. Check the electrical connections again according to the figure in chapter 6.4
If the e-bike does not have a display, use the RideControl app for the check, see FAQ
chapter 13. You can also use the wireless Ridecontrol Plus display. Since the app or
the Ridecontrol Plus can only connect after the e-bike has been turned on, the value
11km/h will not be displayed because the connection process takes longer than 10
seconds. In the event of an error, however, you will see the display of 12km/h
(7.5mph).
►
Then check whether you can switch on the speed mode as described in the chapter 7. If this is
not possible, check the electrical connections again carefully.
Set idividual activation code
If you want to set an individual code to protect the tuning from unauthorized use:
►
Set the activation code according to the instructions in chapter 8 activation code now.
►
Then check if you can activate the tuning with the set code.
►
Switch the e-bike off again and remove the battery.
6.6
Finalize installation
►
Place the tuning module and the connectors in a suitable location.
No uniform installation location can be defined
Due to the different frame geometries and covers, it is not possible to define a uniform
installation location. It is often possible to place the module in the down tube, in the seat
tube, in the connection area of the motor or under a side cover.
►
Lay the cables so that they are not crushed when the motor is folded up.
►
Fold the motor back up and refit the screws (6), (7) and (5).
►
Tighten the screws (6) and (7) to 22Nm and (5) to 11Nm.
►
Refit the motor covers with the screws (2), (3) and (4).
►
Reattach the battery socket with the screws (1).
