1234_BA_E_Rev0 - VOLspeed Giant Syncdrive Sport/Pro V4
© TLI Elektronik GmbH
11
6
Installation
Before you start the installation
Confirm that you have read and understood all previous chapters of these operating instructions
carefully and completely before you start the installation. This is the only way to ensure that you
use the tuning module exclusively for the purpose described in these instructions and as intended
.
The installation described below and all associated instructions refer to the installation example:
Giant Full E+ 0 Pro with Syncdrive Pro motor.
Other e-bike models
With other e-bike models, installation can also be easier. In the example shown here,
the motor is folded down for installation. Often the connectors are already accessible
after removing the lower motor protection cover.
Syncdrive Sport/Life/Core motor
In contrast to the installation example for the Syncdrive Pro, these motors are not
attached to the frame with 4 screws, but only with 3 screws from the left.
The lockring on the chainring spider is fixed here with a 36mm hexagon nut. A special
lockring tool is not required.
6.1
Required tools
Torx spanner TX20 / TX25 / TX30
Allen key 8mm
ISIS crank puller
Lockring tool for Giant Syncdrive Pro / Yamaha PW-X
Chain whip (optional)
Further tools may be necessary
The lower and side motor covers may also be fastened with other screws, depending on the
e-bike model. Additional tools may be required for this.
6.2
Note part number and serial number
For support requests note
►
Make a note of the
Part number (P/N) and
Serial number (S/N) of the tuning module
on the back of these operating instructions.
This way, you always have the data at hand for any
support requests.
IMPORTANT
