1234_BA_E_Rev0 - VOLspeed Giant Syncdrive Sport/Pro V4
© TLI Elektronik GmbH
19
►
Now set your own code by pressing the desired keys.
►
After pressing the first key, the default code is deleted and instead the currently pressed key is
displayed as the total odometer reading (ODO), see input example step 2.
►
With each keystroke, the digit corresponding to the current key is now appended to the right, see
input example step 3 – 7.
►
If more than 5 keystrokes are entered, the first digit is deleted, see step 7.
►
The code can consist of a minimum of one keystroke and a maximum of 5 keystrokes.
Input example:
Step
Key
ODO Note
1
-
1212 Code: Minus | Plus | Minus | Plus
2
Walk
5 Code: Walk
3
Walk
55 Code: Walk | Walk
4
Plus
552 Code: Walk | Walk | Plus
5
Minus
5521 Code: Walk | Walk | Plus | Minus
6
Light
55214 Code: Walk | Walk | Plus | Minus | Light
7
Walk
52145 Code: Walk | Plus | Minus | Light | Walk
Note down the set code. Then switch off the e-bike. This saves the code. If you want to
change the code again, simply switch the e-bike back on and enter it again. Afterwards
restore the wiring to its original condition.
8.3
Delete code
Switch on the e-bike. “1212” is displayed as the total kilometre reading. Then switch
the e-bike off again. This deletes the individual code. Then return the wiring to its
original state.
Ridecontrol Plus
After switching on the e-bike and the display, it takes about 30 seconds until the display is
connected to the e-bike and the values are shown.
Old code invisible
If a code was already set previously, it is deleted. Unauthorised reading of the code is
therefore not possible.
Check code entry
Before re-assembling your e-bike, be sure to check that you can
activate the speed mode with the set code.
