1234_BA_E_Rev0 - VOLspeed Giant Syncdrive Sport/Pro V4
© TLI Elektronik GmbH
22
11
Restore factory settings
The tuning module sets itself up automatically. A conversion to another e-bike or another display is
automatically detected. Nevertheless, it is possible to reset the tuning module to the factory
settings. Thereby the following values are reset:
The limit is set to 32km/h (20mph).
Any existing individual activation code will be deleted.
The mileage and wheel circumference is taken from the motor.
Activation code forgotten
If you have forgotten the set activation code and therefore can no longer activate the
speed mode, you must first delete the activation code.
►
To restore the factory settings, first activate the speed mode and then enter the following
sequence quickly using the keys:
+ - - - + - +
►
The module is now reinitialized. The display shows 11.1km/h (6.8mph) for 10 seconds. As soon as
0.0km/h is displayed again, the process is completed.
12
Status display
Certain operating states are displayed by the tuning module as speed to inform the user about
them.
Speed
Meaning
11 km/h
6.8mph
Initialization in progress. The value is displayed for 10 seconds after switching
on for the first time or after resetting to factory settings.
12 km/h
7.5mph
Speed sensor signal faulty. Check wiring.
13
FAQ
Speed mode cannot be activated.
Probably an individual activation code is set. If known, you must enter this for activation. If not
known, delete the code as described in chapter 8.
Is the total mileage correct even after removing the module?
Yes, the total kilometers measured by the motor control unit are not changed by the tuning. This is
ensured by a compensation function in the tuning module that works continuously in the
