1234_BA_E_Rev0 - VOLspeed Giant Syncdrive Sport/Pro V4
© TLI Elektronik GmbH
18
8
Individual activation code
With an individual activation code, the speed mode can only be activated by entering this code. This
prevents unauthorized activation of the tuning. The code always consists of a self-definable
sequence of one to a maximum of five keystrokes that must be pressed in the set sequence.
8.1
Preparation
►
Switch on the e-bike and set the display to show the odometer reading (ODO) and then switch it
off again.
Display Unit
If the display is set to mph, temporarily change it to km/h.
Information on this can also be found in the FAQ, chapter 13.
►
Disconnect the two smaller, three-pin connectors of the tuning module from the motor and the
speed sensor and plug them together as shown in the following figure.
8.2
Set code
Switch on the e-bike. “1212” is displayed as the total mileage. This is the default code.
Each digit represents a key according to the following table.
“1212” corresponds to the code: Minus | Plus | Minus | Plus
Digit
Key
1
Minus
2
Plus
3
Info (not always available)
4
Light
5
Walk (only from model year
2021)
