Volkswagen 1995 Volkswagen Golf III GL, Руководство по обслуживанию

Страница: 6 / 60

Fig. 3: Sliding Out Lock Carrier
Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig. 4: Exploded View Of Lock Carrier
Courtesy of VOLKSWAGEN UNITED STATES, INC.
ENGINE
Removal (Except Beetle)
1. Disconnect and remove battery. Drain engine coolant by disconnecting coolant hose from thermostat
housing. Disconnect radiator hoses. Remove front bumper/grille assembly (lock carrier). See Fig. 5 .
2. On vehicles equipped with A/C, it is not necessary to discharge A/C system. Remove receiver-dryer
mounting bolts. DO NOT disconnect hoses from receiver-dryer. Remove accessory drive belt.
Remove radiator with fan and condenser attached. Set radiator/condenser assembly in front of engine
mount. See
Fig. 6 . Remove A/C compressor with hoses attached and set aside with
radiator/condenser assembly. DO NOT stress refrigerant hoses.
3. On all vehicles, remove intake air duct. Disconnect all electrical connectors, cables and hoses that
interfere with engine removal. Disconnect power steering pump with bracket and set aside. DO NOT
disconnect power steering hoses. Remove axle shafts from transaxle. See AXLE SHAFTS - FRONT
article in DRIVE AXLES. Leave fuel lines connected and remove cold start injector and warm-up
regulator.
NOTE: Engine is removed from vehicle with transaxle attached. Obtain radio anti-
theft code before disconnecting battery.
1995 Volkswagen Golf III GL
2.0L 4-CYL
1 января 2005 г . 1:18:59 Page 6 © 2004 Mitchell Repair Information Company, LLC.