Volkswagen 1995 Volkswagen Golf III GL, Руководство по обслуживанию

Страница: 25 / 60

Fig. 19: Removing Timing Belt (Except Beetle)
Courtesy of VOLKSWAGEN UNITED STATES, INC.
Installation
1. Move camshaft slightly off its timing mark. Place crankshaft at TDC by aligning flywheel (M/T) or
drive plate (A/T) TDC marks. Remove distributor cap. Rotate intermediate shaft until rotor is pointed
at No. 1 cylinder mark. See
Fig. 17
. Align mark on camshaft sprocket with mark on belt guard. See
Fig. 18 .
2. Install timing belt around crankshaft, intermediate shaft and camshaft sprockets. Install drive belt
tensioner. Rotate tensioner clockwise to tension timing belt. Tighten tensioner mounting bolt to
specification. See
TORQUE SPECIFICATIONS .
3. Rotate engine 2 times and check belt tension. It must be possible to twist timing belt 90 degrees with
thumb and forefinger half-way between camshaft and intermediate shaft sprockets. See Fig. 22 .
Adjust tension as necessary. To complete installation, reverse removal procedure. When installing
accessory belt, be sure belt is correctly seated in pulleys.
NOTE: Disregard marking on intermediate shaft drive belt sprocket.
1995 Volkswagen Golf III GL
2.0L 4-CYL
1 января 2005 г . 1:19:00 Page 25 © 2004 Mitchell Repair Information Company, LLC.