Vivreau V3-205, Руководство пользователя, Страница: 20 / 28

20
V3-205 Dispensing System Owner’s Manual
Section 6
Maintenance
INSPECTING THE CO
2
CYLINDER
Open the Front Door and inspect the CO
2
Regulator Gauge.
Make sure Cylinder Valve is open.
If the CO
2
Cylinder is nearly empty, the Needle
on the Gauge will be in the Red Zone.
CO
2
Regulator Gauge
CO
2
Regulator Gauge
Replace Cylinder if needed.
CLEANING THE COOLING SYSTEM
CONDENSER GRILLE
The Cooling System Condenser Grille is located
on the front of the unit.
Condenser Grille Location
CAUTION
Condenser Grille must be kept
clean to allow proper cooling of components.
Unit damage will occur due to overheating!
The Cooling Fins must not be blocked and must
maintain a minimum distance of 4” to other objects.
Never cover the Cooling Fins.
Never place objects in front of the Cooling Fins.
Clean the Cooling Fins with a suitable brush or
with a vacuum cleaner.
Degrease with a soft cloth sprayed with degreaser.
CAUTION
Never spray degreaser or any
other liquid into the Condenser Grille.
EXTERIOR CLEANING
Wipe all surfaces with a soft cloth and non-
abrasive cleaner.
IMPORTANT _________________________
Never use abrasive cleaners to clean the equipment.
CHANGING A CO
2
CYLINDER
WARNING
Wear protective gloves and
safety glasses when changing CO
2
Cylinders.
Close the Valve on top of the empty Cylinder.
Close Empty Cylinder Valve
Using the proper wrench, loosen the Nut on
the Cylinder to disconnect the High-Pressure
Hose or Primary Regulator. Allow residual gas
to escape from the hose.
WARNING
The line is pressurized. Pressure
will be released while performing this
procedure. Handle carefully.
Disconnect High-Pressure Hose
Place the Regulator within safe reach.