3. POWERMASTER-10 G2 INSTALLATION
12
D-304762 PowerMaster-10/30 G2 Installer's Guide
3.6 Adding Wired Zones or PGM Device
Required tools: Cutter and slotted screwdriver - 3 mm blade.
PowerMaster-10 G2 wiring is shown in Figures 3.6a – 3.7b.
CABLES ROUTING GUIDE
A.
Cables entry options
B.
Back unit
C.
Cable clips
To Route the Cable:
1.
Remove the left or
right side cables
entry knockout(s)
and enter the
required cable(s)
2.
Remove and use as
cable clamp(s)
To Route the Cable (continued):
3.
Position the clamp (1 of 2) as shown and then rotate into place.
4.
Using a slotted screwdriver press downward gently on the point illustrated in the drawing. Make sure the clamp is
locked (a click is heard).
Figure 3.6a – Cable Wiring
