Vision 1330B, Руководство пользователя, Страница: 9 / 48

6)3)/.å"å/7.%23å'5)$%
System Operation
./#()20å-%4(/$åå
This method of arming is identical to
the “Normal” method except there is no
siren chirp emitted after you arm. En-
sure that all doors are closed and then press
Button-III on the Pager remote. After you press But-
ton-III, the doors will lock and hazard lights will flash once (if so installed).
The Pager Remote will beep once and update (see Fig-1 ), and Status LED
will light solid for 5 seconds. Triggers (sensor, door, etc.) are ignored for
the first 3 seconds while the LED is lit solid. (See “Error Chirp” below.)
å
3%.3/2å"90!33å-%4(/$åå
This method of arming allows you to
disable all sensors (e.g., shock sensor)
while keeping all other alarm triggers
active (e.g., door, trunk, ignition). Press
Pager Buttons I & II at the same time then release.
The doors will lock and hazard lights will flash once (if so installed). The
siren will chirp 1 time, the Pager will beep once and update (see Fig-1 ),
and Status LED will light solid for 5 seconds. Triggers (sensor, door, etc.)
are ignored for the first 3 seconds while the LED is lit solid. (See “Error
Chirp” below.)
0USHå"UTTONS
I å II
0USH
"UTTONå III
%RRORå#HIRP
When you arm the 1330B, the system ignores all trigger sectors (e.g., door,
sensor, ignition, etc.) for the first 3 seconds while Status LED is lit solid.
If there is still an unsecured sector after the 3 seconds, the siren will chirp
2 times (“error chirp”) and the hazard lights will flash twice. (In Silent
Mode, no chirps will sound.) If the unsecured sector is later secured (i.e.,
the opened door was later closed), the system will silently re-enable that
sector 5 seconds later. (Also see “Exit Delay Time Selection” on page 14.)
å./4% You will not receive any notification on your 2-way pager dur -
ing an error chirp condition.