Vision 1330B, Руководство пользователя, Страница: 20 / 48

Úåå+)2!-%+å).#
FORCE RESET
In the event the battery in your remote dies or the remote itself is lost, the
1330B can be manually reset (i.e., “disarmed”) using a secure procedure.
0URPOSE
The default Reset Code is factory set to “6.” It is strongly recommended
that you change this code to something unique soon after your 1330B sys -
tem is installed.
The following procedure will allow you to change the Reset Code:
Perform Steps 1 & 2 as described on page 13, turning the Ignition on- 1.
and-off 20 times. Hazard lights will then flash 20 times.
After the vehicle hazards flash 20 times, turn IG on and leave it on. 2.
The Status LED will light solid for 20 seconds and then it will start to 3.
flash very slowly (up to 30 times). Decide beforehand what code you
want to program (1~30). When the number of flashes matches the code
you wish to program, quickly turn off IG. The Status LED will now flash
the same number of times as the Reset Code you just programmed, and
the siren will chirp 3 times and vehicle hazards will flash 3 times.
./4% Make time now to record your new Reset Code and store it in
a safe place.
0ROGRAMMINGå9OURå5NIQUEå2ESETå#ODE
With the system armed, open the driver’s side door. 1. The siren will now
go off.
With the door still open, turn the Ignition ON and 2.
OFF the same number of times as the Reset Code you
programmed. (If no unique Reset Code has been pro-
grammed, then turn the Ignition ON and OFF 6 times.)
When the siren finishes sounding for 30 seconds, the siren will turn off
and the system will then be disarmed.
5SINGå9OURå2ESETå#ODEåTOå$ISARM
ON
ST
ACC
OFF