Vision 1330B, Руководство пользователя, Страница: 22 / 48

6)3)/.å"å/7.%23å'5)$%
TRANSMIT TER LEARNING
You can program additional remotes to your 1330B system, or program a
remote to replace one that you have lost. You can program any combina-
tion of pagers or 1-way transmitters, up to a total of 3.
0URPOSE
The following procedure will allow you to program transmitters:
Perform Steps 1 & 2 as described on page 13, turning the Ignition on- 1.
and-off 20 times. Hazard lights will then flash 20 times.
After the vehicle hazards flash 20 times, you have 10 seconds to press 2.
and release Button-I on the first transmitter you wish to program. The
siren will then chirp once and the hazard lights will flash once to con -
firm your transmitter is learned. You will then have 10 seconds to press
and release Button-I on the next transmitter you wish to program. (You
can program up to 3 total.)
Turn the Ignition on-and-off. The Status LED will flash the same num - 3.
ber of times as the Force Reset Code, and the siren will chirp 3 times and
the hazards will flash 3 times. Transmitter learning is now complete!
0ROGRAMMINGå4RANSMITTERS
å)-0/24!.4
When programming a pager along with 1-way trans-
mitters, you must program the pager first. If you don’t program the pager
first, the pager may not be able to receive transmissions from the vehicle.
Also, when programming more than one pager, only the first pager pro
-
grammed will receive communication from the vehicle. In other words,
there is little meaning to have more than one pager because the second
pager will only act as a 1-way transmitter.
å./4%
Initiating Transmitter Learning deletes all transmitters from
memory for security. You must therefore relearn all your existing re-
motes each time you want to learn new remotes.