Victaulic VicFlex AB12, Руководство по монтажу на месте

Страница: 170 / 204

I-VICFLEX_170 TECHNICAL DATA FOR FLEXIBLE HOSES REV_A
SERIES AH1/AH1-CC FLEXIBLE HOSE FRICTION
LOSS DATA (FM)
NOTICE
• The following table contains FM friction loss data. Always refer to the applicable
“Listing and Approval Information – Flexible Hose and Bracket Combinations”
section to verify the listings/approvals for the particular flexible hose/bracket
combination.
Model
Length of
Flexible
Hose
inches/
mm
Outlet Size
1
inches
Equivalent
Length of
1-inch/33.7-mm
Schedule 40
Pipe
2
feet/
meters
Maximum Number
of 90° Bends 3
AH1-31
AH1-CC-31
31
790
1/2
35.7
2
10.9
3/4
32.9
10.0
AH1-36
AH1-CC-36
36
915
1/2
42.1
2
12.8
3/4
39.2
11.9
AH1-48
AH1-CC-48
48
1220
1/2
57.5
3
17.5
3/4
54.4
16.6
AH1-60
AH1-CC-60
60
1525
1/2
72.9
4
22.2
3/4
69.5
21.18
AH1-72
AH1-CC-72
72
1830
1/2
88.4
4
26.9
3/4
84.7
25.8
1
3/4-inch/DN20 outlet data shown with K14.0 - For other K-factor friction loss data, refer to Victaulic
®
submittal 10.95.
2
7-inch/178-mm minimum bend radius (tested with standard 5 3/4-inch/146-mm length straight
reducer).
3 A higher number of bends may be permitted, provided the sum of degrees is equal to or less than
the total maximum allowable degrees of bends (e.g. Two 90° bends equal 180°. Three 90° bends
equal 270°). The minimum bend radius and maximum number of 90° offset (bends), stated in these
installation instructions, refer to the final installed condition of the hose.
•
For friction loss data for elbows, refer to Victaulic
®
submittal 10.95.
• When using a No. 101 90° Elbow or a No. 102 Straight Tee in place of a Style 108 Coupling on
the end of a Series AH1-CC Flexible Hose, the friction loss data shown above shall be added to
the No. 101 or No. 102 friction loss data published in Victaulic
®
submittal 10.54.
NOTE : Differences in equivalent lengths are due to varying test methods, per FM 1637 standards.
Refer to these standards for additional information regarding friction loss test methods.