Victaulic VicFlex AB12, Руководство по монтажу на месте

Страница: 122 / 204

I-VICFLEX_122
STYLE VS1 DRY SPRINKLER INSTALLATION
FOR FIRE PROTECTION SERVICE REV_A
Remove Hex Cap
Screw for Installation
3. Using a
5/16
-inch hex socket, remove
the hex cap screw from the bracket.
4. Snap the bracket onto the weld fitting,
as shown to the left. Verify that the slot
of the bracket aligns with the lip on the
weld fitting.
• An alternative to step 4 is to snap
the bracket onto the outlet tube, as
shown on the left.
5. Place the bracket assembly in the
desired position on the wood or metal
joist/stud. Verify that the sprinkler is
oriented in the proper position.
5a. Using a
5/16
-inch hex socket,
re-install the hex cap screw. Tighten the
hex cap screw to 15 inch-lbs/1.7 N•m
(approximately one to two turns past
hand-tight). This will retain the sprinkler
orientation in relation to the bracket
mounting flanges.