Victaulic VicFlex AB12, Руководство по монтажу на месте

Страница: 45 / 204

I-VICFLEX_45
STYLE AB5 BRACKET INSTALLATION FOR
WOOD OR METAL JOISTS/STUDS AND CD
PROFILE (60 MM) CHANNEL SYSTEMS REV_A
INSTALLATION FOR WOOD JOISTS/STUDS
1.
Install the flexible hose into the sprinkler piping and the sprinkler reducing nipple onto
the flexible hose by following the applicable instructions in the “Connection to Sprinkler
Piping” and “Connecting the Sprinkler Reducing Nipple to the Flexible Hose” sections.
2.
Place an end bracket assembly onto
each end of the square bar so that the
wing screw is facing outward (away from
the center gate assembly), as shown on
the left.
3.
Place the end bracket assembly up against the inside surface of the one wood joist/
stud with the top of the 90° bend resting on top of the wood joist/stud, as shown above.
Repeat this step for the other end bracket assembly.
4. Install the Style AB5 Bracket to
the wood joists/studs by using one,
1 1/4-inch/32-mm long #10 wood screw in
each end bracket location shown in the
photo on the left. Verify that the top of
the 90° bend remains flush with the top
of the wood joist/stud during installation
of the wood screw.
5. Secure the end brackets to the square bar by tightening the wing screw on top of each
end bracket assembly until the bottom of the wing screw reaches metal-to-metal contact
with the top of the end bracket.
6. Complete the installation by following the applicable instructions in the “Sprinkler
Reducing Nipple Installation” and “Sprinkler Installation” sections.