Victaulic VicFlex AB12, Руководство по монтажу на месте

Страница: 131 / 204

I-VICFLEX_131 CONNECTION TO THE SPRINKLER PIPING REV_A
1-INCH/DN25 IGS
™
CONNECTION TO THE
SPRINKLER PIPING USING A SERIES AH1-CC,
AH1-CC-LP, AH2-CC, AH2-CC-LP, OR AH2-CC-300
VICTAULIC
®
VICFLEX
™
FLEXIBLE HOSE
INCORRECT - Orignal Groove System (OGS) Groove Profile
CORRECT - IGS Groove Profile
Pipe and grooves are not shown to scale
The Style 108 Coupling of the Series AH1-CC, AH1-CC-LP, AH2-CC, AH2-CC-LP, or
AH2-CC-300 shall be used
ONLY
with sprinkler piping connections that are prepared to
Victaulic
®
IGS
™
proprietary groove specifications. DO NOT attempt to install the coupling
on sprinkler piping connections that are prepared to any other groove specification.
Refer to Victaulic
®
publication 25.14 for the IGS
™
groove specification, which can be
downloaded at victaulic.com.
DO NOT use the Style 108 Coupling for sprinkler-piping-to-sprinkler connections. For
sprinkler-piping-to-sprinkler connections, the Style V9 shall be used.
WARNING
• The flexible hose shall not be bent or fluctuated up-and-down or side-to-side
when pressurized.
Failure to follow this instruction could cause improper sprinkler operation, resulting
in death or serious personal injury and property damage.
DO NOT REMOVE
NUT/BOLT FOR INITIAL
INSTALLATION
1. DO NOT DISASSEMBLE
THE COUPLING:
The Style 108
Coupling of the Series AH1-CC,
AH1-CC-LP, AH2-CC, AH2-CC-LP,
or AH2-CC-300 Flexible Hose is
designed so that the installer does
not need to remove the nut, bolt,
or linkage for initial installation.
This facilitates installation by
allowing the installer to directly
insert the sprinkler piping’s
grooved end into the coupling.
2. The outside surface of the sprinkler piping, between the groove and the end of
the sprinkler piping, shall be generally free from indentations, projections, weld seam
anomalies, and roll marks to ensure a leak-tight seal. All oil, grease, loose paint, dirt, and
cutting particles shall be removed.
The sprinkler piping’s outside diameter (“OD”), groove dimensions, and maximum
allowable flare diameter shall be within the tolerances published in current Victaulic
®
IGS ™ specifications, publication 25.14, which can be downloaded at victaulic.com.
3.
Check the gasket to verify that it is suitable for the intended service. The color code
identifies the material grade. Refer to Victaulic
®
publication 05.01 for the color code
chart, which can be downloaded at victaulic.com. Refer to Victaulic
®
publication
05.01 for the color code chart, which can be downloaded at victaulic.com, and the
“NOTICE” on the following page for important gasket information.