Victaulic VicFlex AB12, Руководство по монтажу на месте

Страница: 145 / 204

I-VICFLEX_145
SPRINKLER REDUCING NIPPLE INSTALLATION
REV_A
SPRINKLER REDUCING NIPPLE INSTALLATION
FOR STYLE ABBA/ABMM BRACKETS
Square Bar
Retaining Screw
1. For floor-above-mount, cantilever-
mount, and temporary fire protection
configurations:
Move the bracket body
to the desired location on the square bar.
NOTE:
The square bar retaining screw
may need to be loosened with a T25 Torx*
recessed drive bit to allow the bracket
body to slide on the square bar.
Adjustment
Screw
2. Using a T25 Torx* recessed drive bit,
loosen the adjustment screw, then push
open the gate.
NOTE: The adjustment
screw is staked to resist removal.
3.
Slide the sprinkler reducing nipple
into the bracket body, then close the
gate. Close the gate around the sprinkler
reducing nipple.
NOTE: The gate will
snap together tightly around the sprinkler
reducing nipple.
4. Using a T25 Torx* recessed drive bit,
tighten the adjustment screw to a torque
of 80 inch-lbs/9.0 N•m (until adjustment
screw makes metal-to-metal contact with
bottom of gate).
NOTE: The sprinkler
reducing nipple can be adjusted after the
wall or ceiling is installed by using this
adjustment screw.
5. Using a T25 Torx* recessed drive bit,
tighten the square bar retaining screw to a
torque of 72 inch-lbs/8.1 N•m.
* Torx is a registered trademark of Acument Global Technologies