Vicon surveyor 2000 XX004, Инструкция по установке и эксплуатации

Страница: 22 / 36

12
••••
Installation XX004 Rev 500 Surveyor2000 Pressurized Housing Camera Dome
15. Attach the Housing’s Safety Cord to the Camera Drive’s Clip. Tilt the Camera Drive down and orient the
three (3) outside slots in the mid-section PC board with the three (3) standoffs in the Housing and lower it
until the three (3) captive screws touch the Housing’s standoffs. The slots will only line up one way.
Tighten the screws.
16. Lift the Housing Assembly out of the carton, flip it over and shake it to remove any debris. Place it back in
the carton.
17. Verfiy that the O-ring in the groove of the Housing Assembly’s seal surface is properly seated and
glistening with vacuum grease. If not, seat the O-ring in the groove, remove any other extraneous debris
and rub additional vacuum grease on it.
18. Place the Trim Ring/Lower Dome Assembly on the Housing Assembly’s seal surface and align the eight
(8) Housing holes with the eight (8) Trim Ring/Lower Dome holes. Install the eight (8) screws and tighten
only with a torque wrench set for 15 in. lb (170 N cm) of force. Use an alternating (star) pattern to tighten
all the screws.
Figure 10
Wiring/Configuration