Vicon surveyor 2000 XX004, Инструкция по установке и эксплуатации

Страница: 12 / 36

2
••••
Introduction XX004 Rev 500 Surveyor2000 Pressurized Housing Camera Dome
Pressurized Housing Components
The Pressurized Housing is comprised of a Housing, a
Surveyor2000 Camera Drive and a Trim Ring/Lower
Dome Assembly as shown in Figure 1. This assembly is
the heart of every prepackaged Pressurized Housing
version of the Surveyor2000 Camera Dome. With the
addition of a mount, the Pressurized Housing version can
be equipped for indoor or outdoor wall mount or pipe
mounting.
Housing
The Housing is a combination aluminum frame and
molded polyethylene plastic UV-resistant weather-proof
shell. It is used as the mounting frame for the Camera
Drive that mounts to the three (3) standoffs on the inside
of the Housing. The interior is environmentally controlled
using a thermostatically controlled Heater/Fan Assembly.
A Safety Cord and Clip are provided on the inside to
connect the Camera Drive Latch during installation. The
top of the Housing is equipped with a Fill Valve
(Schraeder type), a Pressure Switch and a Pressure
Relief Valve. In addition, a 23-pin female, pressure-rated
connector is installed at the top for signal connection.
There is also a rectangular shaped flange surface with a
four-hole bolt pattern, covered with gasket material, that is
used to attach a pipe or wall mount. The inside of the
Housing is factory-prepared for the installation of the
Surveyor2000 Camera Drive Mechanism. The base of the
Housing has a machined circular groove with an O-ring
gasket installed. This is the seal surface for the lower half
of the Housing that mates with the Trim Ring/Lower Dome
Assembly.
Camera Drive
The Camera Drive is comprised of an integral Camera,
Pan-and-Tilt Drive and CPU. The Camera Drive quickly
and accurately positions the Camera in 360
°
of pan angle
and 90
°
of tilt angle. All wiring is made directly to the top of
the Camera Drive.
Trim Ring/Lower Dome Assembly
The Trim Ring/Lower Dome is an assembly comprised of
a 9.8-inch (249 mm) diameter clear acrylic plastic shell
and a color coordinated Trim Ring. The Trim Ring/Lower
Dome Assembly is is attached using eight (8) screws that
require a torque wrench. It is also equipped with a Safety
Latch that is used to attach the Housing’s Safety Cord.
Refer to the Maintenance Section of this manual for
instructions on handling and care of this Lower Dome.
Figure 1
Pressurized Version Surveyor2000
Components