Vicon RV 1601, Руководство по эксплуатации

Страница: 74 / 108

Chapter 10
G0201WAD3EN 72
net wrap
10.8 Electronic settings of the net wrap -
AUTOFORM
10.8.1 Changing the number of wraps
1
Select net wrap push button (if still required).
2
With button select wrapping programme P5.
3
The number below the lh picture gives the number of
net wraps.
4
Push button till the value underneath the lh picture
starts blinking.
5
Set the desired value pushing the buttons and .
6
Confirm that new value pushing button .
10.8.2 Resetting the net used indication
The number of metres net used since the last resetting
is shown on the display during work.
1
Select net wrap pushing button (if still required).
2
With button select wrapping programme P5.
3
The number below the rh picture gives the number of
metres of net used since the last resetting.
4
Push button till the value underneath the rh picture
starts blinking.
5
Push button , the value now is reset to zero.
6
Confirm by pushing button .
10.9 Mechanical adjustments of the net
wrap
10.9.1 Adjustment of net brake
1
Slacken bolts (1) two turns only.
2
Take care that net brake is on full load (actuator fully
retracted) see position B.
3
Move radius of net brake in relation to radius disc.
4
Tighten bolts (1).
10.9.2 Tension of the net brake
Net tension is adjusted through the net brake. Standard
setting is 20 mm (25/32") with the spring in the last but one
position at the front side.
The above-mentioned setting is a nominal value. This
value depends on e.g. quality of the net, wastage.
If the brake is still cold wrap with lower rpm till the
brake has reached operation tamperature.
W
A0022
1
A B
20 mm
W
A0067