Vicon RV 1601, Руководство по эксплуатации

Страница: 42 / 108

Chapter 6
G0201WAD3EN 40
electronic control system AUTOFORM
6.7.3 Baler shape sensor calibration
Ensure the chamber is empty.
1
Three times push button .
2
Twice push button , the shown actual value (e.g.
128) is then entered and confirmed.
The rotational sensors are positioned at the lh and rh side
inside the baler. This calibration compensates the lh and rh
sensors with respect to each other.
6.7.4 Correction of bale diameter
1
Four times push button .
2
Change the value by pushing buttons or this
may be adjusted from +10 to -10 cm (+4" to -4").
3
Confirm new setting by pushing button .
6.7.5 Bale growth sensor calibration
Attention:
Open tailgate, then place stop pin in the lower hole
in the lateral wall. Then lower the tailgate pressure-
less (floating position) till the tensioner arm rests on
the stop pin. This is the basic position for calibration.
1
Five times push button .
2
Twice push button the actual value is then entered
and confirmed.
6.7.6 Twine run control (option)
1
Six times push button .
2
Set the value to 0 or 1 pushing the buttons or .
3
Confirm new setting by pushing button .
0 = sensor disengaged
1 = sensor engaged
W
A0054
dD4
dD5
dD6
dD6
dD7