Vicon RV 1601, Руководство по эксплуатации

Страница: 27 / 108

Chapter 5
G0201WAD3EN 25
electronic control system INFOBALE
5.2 Machine control unit
The machine control unit is positioned behind the front lh
side panel. The machine control unit contains the electronic
control elements for both twine tie and net wrap.
5.2.1 Control elements and their function
1
Toggle switch SOS (1):
activation of twine tie emergency control
activation of net wrap emergency control
2
Toggle switch (2) twine end distance / calibration:
Position 1: twine end distance = 10.5 cm resp.
Position 2: twine end distance = 13.5 cm resp.
Position 3: twine end distance = 15.5 cm resp.
Position 1: setting calibration to RV 1601 (WD) resp.
Position 3: setting calibration to RV 1901 (WA).
3
Rotatable knob (3) to set the amount of twine or the
amount of net.
4
Rotatable knob (4) to set the bale diameter.
5
Push button (5) Reset
6
Bale counter (6) (total number of bales, not resetable)
5.2.2 Twine wrap settings
The distance of twine end wraps is pre-set with the toggle
switch (2) on the machine control box (positions 1, 2 and
3).
Rotatable knob (3):
1
Position minimum: 3 lateral wraps, 4 central wraps and
3 end wraps in between at either side
2
Middle position: 3 lateral wraps, 6 central wraps and
3 end wraps in between at either side
3
Position maximum: 3.5 lateral wraps, 8 central wraps
and 3.5 end wraps in between at either side.
The above-mentioned number of wraps are nominal
values only since the effective number depends upon
the pto speed.
5.2.3 Net wrap settings
The number of net wraps is pre-set with rotable knob (3) on
the machine control box.
Position:
1
minimum: 2 wraps
2
maximum: 5 wraps
The number of net wraps does not depend upon the
bale diameter. At the start of wrapping the control
system automatically calculates the quantity taking
into account the actual bale diameter. Only the pto
speed influences the real number of wraps.
SOS
000000
PROG
W
A0213
1
5
6
2
3
4
W
A0214
min
max
max
1 2 3
min
(WA) (WD)
1
2
3
4