Viavi 87339, Руководство по эксплуатации

Страница: 44 / 198

Testing
3 - 3
Altitude
Numeric Pad: Altitude: 0 to 100,000 ft in 1 ft steps or 0 to
18,288 M in 1 M steps
NOTE:
This field is locked when SIMULATION = DYNAMIC or
TRAJECTORY.
RF Level Numeric Pad: RF level entered as -68 to -130 dBm in Coupler
mode or -93 to -155 dBm in Direct mode.
NOTE: The listed RF Level settings are assuming 0 dBm
settings for Coupler Loss, Coupler Cable and Direct Cable on
the Setup I/O Window. The RF Level entry window will be
reduced by the values entered for these settings.
Display Component Description
GPS SV PRN Displays selected GPS SV PRN’s. Range: 1 to 32
GAL SV PRN Displays selected Galileo SV PRN’s Range: 1 to 36
SBAS Displays SBAS SV PRN, status and System.
Example: 133:INMARSAT 4F3, AMER
Visible SV’s Displays the total number of GPS, Galileo and SBAS SV’s
available in the current simulation scenario.
Carrier Displays selected carrier, dependent on GNSS and Carrier
selections in Setup.
NOTE: The GPS Services and Galileo Services are displayed
in the Services field.
GNSS System: GPS
Carrier: L1 GPS Services: C/A, Pseudo P(Y)
Carrier: L1 no P(y) GPS Services: C/A
Carrier: L2 GPS Services: L2C, Pseudo P(Y)
Carrier: L5 GPS Services: SoL
GNSS System: Galileo
Carrier: E1 Galileo Services: I/NAV, Pseudo-G/NAV
Carrier: E5 Galileo Services: I/NAV, F/NAV
GNSS System: GPS/Galileo
Carrier: L1/E1 GPS Services: C/A, Pseudo P(Y)
Galileo Services: I/NAV, Pseudo-G/NAV
Carrier: L5/E5 GPS Services: SoL
Galileo Services: I/NAV, F/NAV
Services Displays GNSS service generated.
Current Sim. Date Displays Date in DD/MM/YYYY format.
Speed Displays speed in MPH or Km/h when running a dynamic or
trajectory simulation, dependent on Speed setting on the
Route Edit page.
Current Sim. Time Displays Time in 24 Hr format HH/MM/SS.
NOTE: Displayed in uncorrected UTC time.
Elapsed Time Displays elapsed time in 24 Hr format HH/MM/SS.
Altitude Rate Displays Altitude Rate in ft/min or m/min when running a
dynamic simulation, dependent on Altitude Rate setting on the
Route Edit page.