Viavi 138156, Руководство по эксплуатации

Страница: 189 / 404

Operation, Remote Operation
RTCA/DO-260 Test Commands
1-2-5 ATC-5000NG ATC/DME Test Set Operation Manual Rev. L0
Page 26 Subject to Export Control. See Cover Page for details. February 2020
5.6.7.2.4 LAST ENERGY CHIP
5.6.7.3 CONFIDENCE TEST PARAMETERS
5.6.7.3.1 BAD CHIPS
5.6.7.3.2 ENERGY CHIPS
5.6.7.4 OVERLAPPING PARAMETERS
5.6.7.4.1 PULSE DELAY
Command Syntax:
{:ATC |:ATC5000NG}{:DO260}{:TYPE}{:BITFAILURES |:BITF }
{:CHIPS}{:LAST}SP<numeric>CR
Description:
This command sets the last energy bit of the bad chips pulse.
Numeric:
0 for no bad chip (decimal ASCII)
1 to 112 if the reference is a long Mode S (decimal ASCII)
1 to 56 if the reference is a short Mode S (decimal ASCII)
Example:
:ATC:DO260:TYPE:BITF:CHIPS:LAST 39\r
Default:
0
Query:
:ATC:DO260:TYPE:BITF:CHIPS:LAST?\r
Return:
39
Command Syntax:
{:ATC |:ATC5000NG}{:DO260}{:TYPE}{:CONFIDENCE |:CONF }
{:BADP}{:CHIPS}SP<numeric>[,<numeric>[,<numeric>[,<numeric>[,<numeric>]]]]CR
Description:
This command sets the list of bits with bad chip pulses. This command allows defining up to five
different bad bits.
Numeric:
1 to 112 if the reference is a long Mode S (decimal ASCII)
1 to 56 if the reference is a short Mode S (decimal ASCII)
Example:
:ATC:DO260:TYPE:CONF:BADP:CHIPS 33\r
Default:
No selection
Query:
:ATC:DO260:TYPE:CONF:BADP:CHIPS?\r
Return:
33
Command Syntax:
{:ATC |:ATC5000NG}{:DO260}{:TYPE}{:CONFIDENCE |:CONF }
{:ENERGY}{:CHIPS}SP<numeric>[,<numeric>[,<numeric>[,<numeric>[,<numeric>]]]]CR
Description:
This command sets the list of bits with energy on both halves of the chip. This command allows
defining up to five different energy bits.
Numeric:
1 to 112 if the reference is a long Mode S (decimal ASCII)
1 to 56 if the reference is a short Mode S (decimal ASCII)
Example:
:ATC:DO260:TYPE:CONF:ENERGY:CHIPS 33,36,45,56\r
Default:
No selection
Query:
:ATC:DO260:TYPE:CONF:ENERGY:CHIPS?\r
Return:
33,36,45,56
Command Syntax:
{:ATC |:ATC5000NG}{:DO260}{:TYPE}{:OVERLAPPINGPULSE
|:OVERLAP}{:PULSE}{:DELAY}SP<numeric>CR
Description:
This command sets the pulse delay relative to P1. By default, the width is 0 ns.
Numeric:
-20000 to 2000 ns (decimal ASCII)
Example:
:ATC:DO260:TYPE:OVERLAP:PULSE:DELAY 2000\r
Default:
0 ns
Query:
:ATC:DO260:TYPE:OVERLAP:PULSE:DELAY?\r
Return:
2000