9
Installation
ENGLISH
the LNBs to the DiSEqC™ ports as shown in the LNB positions table below. You must then
connect your DiSEqC™ unit to the satellite input on your box (see also pages 9 to 11).
The Quad LNB setup requires that two DiSEqC™ switches are installed, one for each tuner input.
If you have more than one LNB in your antenna, it is recommended, for full PVR functionality, that
you exchange the LNBs for the other satellites also. Universal Quad LNBs are available at your local
installer.
With a Universal Quad LNB there will be two spare signal outputs, where it is possible to connect
an extra box, for example in your bedroom.
LNB positions table
If you change your satellite dish installation, you may need to change your settings so that your box
can tune to all the satellites available - See “Changing the LNB Setup” on page 52.
Connection method 1: To TV and VCR (without SCART)
If wish to connect your box to a TV (with or without a SCART connector) and a VCR (without
SCART connectors), connect up as shown in the diagram on page 10.
Satellite
Position
Recommended DiSEqC™ port
(for multiple LNB set-ups)
Thor
1° West
1
Sirius
5° East
2
Hotbird
13° East
3
Astra
19° East
4
Note
Initially, only a two-way LNB set-up is supported, on DiSEqC™ ports 1 and 2. A three- or four-way
LNB set-up using DiSEqC™ ports 3 and 4 (i.e. for Hotbird and Astra) will be supported after your
box has collected an automatic software update from Viasat.
*DiSEqC™ is a trademark of Eutelsat.