53
Setup
ENGLISH
The LNB Setup menu displays.
2.
Highlight ‘Number of LNBs’, then press
L
or
R
to select the number of LNBs you have in your
set-up.
3.
Highlight ‘Low Band LO Frequency (GHz)’, then use the
number
buttons to enter the
appropriate frequency. If the number is below 10.000, add a leading zero (for example, 09.750).
4.
Highlight ‘High Band LO Frequency (GHz)’, then use the
number
buttons to enter the
appropriate frequency. If the number is below 10.000, add a leading zero (for example, 09.750).
5.
Highlight ‘LNB is powered by STB’, then press
L
or
R
to select either ‘On’ or ‘Off ’. The default
setting is ‘On’.
6.
If you selected ‘2 LNBs’ in step 2, highlight ‘DiSEqC port A is connected to’ then press
L
or
R
to select the correct satellite for the LNB connected to DiSEqC™ port A, either Sirius or Thor.*
7.
‘DiSEqC port B is connected to’ is set to whichever satellite was not selected in step 5
8.
To save your changes, highlight ‘Save New Settings’ then press
OK
, or to cancel, press
BACK
.
9.
If you have changed your LNB setup configuration must then check the signal quality (see
page 51).
You can press the
red
button to reset all settings on the LNB setup menu to their factory defaults.
The default values are shown on the image above.
Setting the Default Transponder
Default values (shown on the image on page 54) are already entered for this setting; under normal
circumstances you do not need to change these. If you change your satellite dish installation, you may
need to change this setting so that your box can tune to all the satellites available.
To change the Default Transponder settings:
1.
On the Installation Setup menu, highlight ‘Default Transponder’, then press
OK
.
*DiSEqC™ is a trademark of Eutelsat.
