29
condition) and NC (Short under normal condition). Wrong setting
will cause error action. When input potential is “---“, it means
disable. Input potential is “High” will require to use NO (Open
under normal condition) and when input potential is “Low”, the
NC (Short under normal condition) will be used. It is suggest
using the device using NC. This means that when it is triggered,
or connection cut off, it will trigger alarm.
Alarm Sound:
This is use to setup the alarm sound when input
terminals is triggered. You can use the 4 built-in sounds for
setting.
Output 1-4:
This setting is to send out control signal to control
external alarm devices when input terminals had been triggered,
each input terminals can setup 1-4 output control. Output setting
“---“means disable, “ON” means active. Please refer to the output
setup instruction above for setting.
3.8 Program
PROGRAM SETUP: PROGRAM 1
1.ENABLE: OFF
2.SUN-SAT OFF OFF OFF OFF
OFF OFF OFF
3.BEGIN TIME: 00:00:00
4.END TIME: 00:00:00
Setting of 4 sets of programs for recording. Each set is based on a week
time. Setting a same recording time for each program. Enable/disable of
each date from Sunday to Saturday can be set independently.
