Vertiv 02131111, Инструкция по установке и эксплуатации

Страница: 9 / 36

Vertiv™ NetSure™ IPE Series Rectifier Installation and User Manual
1
1 Introduction
1.1 General
The NetSure IPE Series provides a rectifier mounted inside an environmentally protective enclosure. The NetSure IPE Series rectifier
can be wall or pole mounted.
1.2 What is in the Box
Refer to Table 1 .
Table 1:
Part Number Description Qty.
02131111 NetSure IPE Series Rectifier 1
21505943 Pole/Wall Mount Kit 1
63126330 Pole Mount Band 2
6312017Y Security Screw Wrench 1
UM02131111 Installation and User Manual 1
1.3 Rectifier Overview
The rectifier provides load power during normal operating conditions. The rectifier is a constant power design. The rectifier is rated
at its maximum output power. This means that, within the normal operating ambient temperature range and input voltage range, the
maximum available output power is a constant 2000 W. Within these ranges, the rectifier operates in one of three modes, depending
upon load demands. Transition between modes is completely automatic. If ambient temperature rises above or input voltage falls
below acceptable values, the rectifier continues to operate but at derated output power levels.
•
Constant Voltage Mode: For any initial output voltage setting from -42 VDC to -58 VDC (factory set at -54 VDC), output
voltage remains constant regardless of load. This is the normal operating condition, in which loads are being supplied. The
rectifier operates in the Constant Voltage Mode unless load increases to the point where the product of load current and
output voltage is approximately 2000 W.
•
Constant Power Mode: As load increases above approximately 2000 W (non-adjustable), output current continues to
increase, but output voltage decreases as required to maintain constant output power. The rectifier operates in the Constant
Power Mode unless load continues to increase to the point where the current limit setting is reached.
•
Constant Current Mode: If load increases to the current limit setting, output voltage decreases linearly to maintain output
current at the current limit setting.
1.4 Rectifier Specifications
The specifications are for a single unit only, unless otherwise noted.
1.4.1 DC Output Ratings
1. Voltage: -42 VDC to -58 VDC, positive ground. Output voltage is factory set at -54 VDC.
2. Output Power and Current: 2000 W (41.7 A) @ 200 VAC to 250 VAC input and -48 VDC output.
3. Output Characteristics: Refer to Figure 1 for a graph of output voltage vs. output current.